How practise I cheque and modify lawn mower oil?

Quick Links:

  • When to Change the Oil
  • How to Bank check the Oil Level
  • Oil Change Steps

When y'all put fresh oil into the crankcase, it volition be a gilded or amber colour. Over time, estrus, clay and agitated air go into the crankcase causing the oil to darken. Dark oil is not only muddy; it has as well lost much of its ability to glaze and protect engine components.

When to Change the Oil

  • Every 50 hours of operation or after every mowing flavor
  • For a new lawn mower engine, you'll also need to change the oil after the showtime five hours of operation.
  • Also bank check the oil every fourth dimension you utilise it. Tough conditions such equally wet grass, heavy grit, high temperatures and rough or hilly terrain, may increase the frequency of required oil changes.
  • The new EXi engines series™ from Briggs & Stratton® makes backyard mower oil maintenance easier than always with Just Check & Add™ Engines.

How to Cheque Oil Level

Checking the oil while the engine is common cold and about of the oil is in the crankcase yields the well-nigh accurate reading.

For oil checking procedures on lawn mower applications, please lookout man our "Checking Engine Oil - Lawn mower Engine" video

Follow These Steps to Change your Oil

Get-go, start by checking the oil level on your dipstick. The oil level of the dipstick should be between the two holes on the dipstick. Overfilling your engine tin exist merely as bad as using onetime oil so make certain to check your dipstick level regularly.

Adjacent, place how to drain the oil on your lawn mower. This can be done through the dipstick tube, drain plug or with an oil extractor tool. From there, it's time to bleed the oil:

  • Run the backyard mower engine for 15 minutes to warm up the oil (imperative to remove all muddy droppings from engine)

  • Plough off the engine and disconnect the spark plug wire

  • Drain the gas from the mower OR identify a plastic sandwich bag over the gas tank and screw the cap on to prevent leaks

  • Insert the oil extractor tube and begin to pump the oil out of the engine

Once you accept removed all the sometime oil and placed it in a container, set the container aside and subsequently you are completed with the oil modify, have this container to your nearest dealership where they can recycle your onetime oil.

At present, y'all can begin pouring in the clean, new oil. Check your operator'due south manual to determine which oil is best for your engine. In this video we used Briggs & Stratton SAE 30 Oil which can be used for most small engines. Once you finish pouring in the new oil, insert the dipstick in the tube and check to brand sure the oil is at the correct level. When the oil is at the correct level, screw on the dipstick cap, put in new fuel if y'all removed it, and and so reconnect the spark plug wire.

WARNING: Always read the engine and equipment manual(s) before starting, operating, or servicing your engine or equipment to avoid personal injury or property damage. Run into an authorized dealer if you lot are unsure of any procedure or accept additional questions. Find all Engine Safety Warnings

Shop Related Maintenance Parts